EazyPod
This section will provide all the necessary information for EazyPod.
- How are the levels set inside the Eazypod to allow for cleaning?
- How can I extend the draining time of my Eazypod Automatic?
- Why is the media in my Eazypod sitting high up and water is flowing down the overflow channels?
- Does the UV need to be switched off on my Eazypod during the cleaning cycle?
- Can you retro fit an Eazypod?
- EazyPod Automatic does not close waste valve
- EazyPod Automatic does not drain to waste
- There is no power/does not initiate cleaning mode to my Eazypod automatic control box.
- Too much maintenance, poor clarity, or EazyPod overflowing
- The pond gets dirty after cleaning my Eazypod
- The K1 Micro doesn’t move well during the cleaning cycle
- The K1 Micro doesn’t move well during the cleaning cycle
- My K1 Micro stays on the surface of the water in my Eazypod and will not sink
- I want to install the EazyPod on a gravity fed system, what height will the water level be?
- What volume of water is send to waste in my Eazypod during a cleaning cycle?
- What are the air stones used for that come with an EazyPod Air / EazyPod Complete?
- How can I extend the cleaning cycle from 6 minutes to up to 10 minutes on my Eazypod Auto?
- What size pump do I need for an EazyPod?
- Can an EazyPod feed a waterfall?
- I want to recess the EazyPod away from the pond. How do I do that?
- Media is escaping and being discharge to waste when cleaning my Eazypod
- Can EazyPod Automatic be gravity-fed?
- Can EazyPod be run gravity-fed?
- Is EazyPod a complete filtration system? Will I need anything else?
- Can EazyPod be upgraded to automatic cleaning?
- Can an old EazyPod be adapted to take smaller K1 Micro?
- How do I replace the waste ball valve on my EazyPod?
- What size pump do I need for an EazyPod?
- What is EazyPod Automatic?
- Is EazyPod a complete filtration system? Will I need anything else?