There is no power/does not initiate cleaning mode to my Eazypod automatic control box. – Evolution Aqua

Check the wiring is correctly installed. Seek advice from a suitably qualified electrician if in doubt.
Check the mains connection to the control box. Check the connection at the mains power and check the wiring inside the control box. Seek advice from a suitably qualified electrician if in doubt.
Check the fuse inside the control box. This is located in the hinged compartment on the left hand side of the pump connector block. The fuse is a standard 10 Amp glass fuse.
Please be aware that every control box system is fully factory tested.
Check the first relay has power, you can test this using an non-contact voltage detector pen.

Related to